During band search, you can manually change the receive mode.
Follow these steps to search for and store active frequencies using band
search.
1. Press BAND. The last selected band number (b followed by a number,
such as b02), SEARCH, and the frequ ency search range appear.
2. To select a different band, enter the band's number (01 -17), or
repeatedly press BAND until the desired band number appears.
3. To step through the band upward or downward in small increments (in
steps of 5, 12.5, or 25 kHz depending on the band), repeatedly press
UP ARROW or DOWN ARROW.
Or, hold down UP ARROW for about 1 second to search up from the
bottom of the band, or DOWN ARROW for about 1 second to search
from the top of the band. UP ARROW or DOWN ARROW appears.
When the scanner finds an active frequency, it stops searching and
displays the frequency's number.
NOTES: To reverse the rapid search direction at any time, hold down
UP ARROW or DOWN ARROW for about 1 second.
To store the displayed frequency in the lowest available channel,
press ENTER. The channel and frequency flash twice, and the
scanner stores the displayed frequency. Then the scanner
continues to search for frequencies.
If there is no empty channel, CH -FULL appears. To store more
frequencies, you must clear some channels. To continue searching
after CH-FULL appears, press CLEAR then UP ARROW or DOWN ARROW.
To store the displayed frequency in the lowest available monitor
memory, press MONITOR. The frequency flashes twice, and MON,
the monitor memory number, and CH flash. To search for another
active frequency in the selected band, hold down UP ARROW or
DOWN ARROW for about 1 second.
If you try to store a frequency in a monitor memory that is
already stored in a channel, -dUPL- flashes then the channel
number and CH, MON, and the frequency flash. If you want to store
the frequency anyway, press MONITOR.
4. To select a different band and search for another active frequency,
repeat Steps 2-3.
Limit Search
You can search for transmissions within a range of frequencies you select,
or you can use one of the scanner's 10 prepro grammed limit search ranges.
NOTES: You can use the scanner's delay feature while using limit search.
During a limit search, you can manually change the receive mode.
The scanner contains there preprogrammed limit search ranges, stored in
To Next Page
Loading...
