EasyManua.ls Logo

Radio Shack Pro-2045 - Advanced Search Operations; Direct Search Actions

Radio Shack Pro-2045
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
6. When the scanner finds a trans-
mission, you can:
Store the displayed frequency
into the current monitor memory
— quickly press
MONITOR
.
Lock out the frequency so the
scanner does not stop on it
again — press
S/S
. The scan-
ner resumes searching.
Continue the search without
storing it or locking it out
press
s
or
t
.
Hold the scanner on the fre-
quency — press
LIMIT
or turn
the rotary tuner either way one
click.
-H-
appears.
Notes:
You can press
s
or
t
while the
scanner displays
-H-
to step
through the frequencies toward
the upper or lower limits.
If you tune to a search skip fre-
quency, the scanner displays
L/O
(see “Search Skip” on
Page 21).
If you program all frequencies
within a limit search range as
search skip frequencies, the
scanner goes to the hold mode.
-H-
appears on the display.
During the limit search, you can
change the modulation (NFM or
AM). See “Changing the Modu-
lation Mode” on Page 28.
Press
LIMIT
again or press and
hold
s
or
t
for more than 1 second
to resume the limit search.
Direct Search
A direct search lets you specify a
starting frequency, then search for ac-
tive transmissions above or below the
specified frequency.
Note:
You can use the delay feature
during a direct search (see “Delay”).
1. Press
MANUAL
.
2. Using the number keys, enter the
frequency (including the decimal
point) you want to start the search
from; or, enter the channel num-
ber containing the starting fre-
quency and press
MANUAL
or
PROGRAM
to select the channel.
3. Press
s
to search up or
t
to search
down starting from the specified
frequency.
-d-
,
SEARCH
, and s
or t appear, and the next available
monitor memory flashes.
Note:
If you enter an invalid fre-
quency,
Error
appears on the
display. To correct this, repeat
Steps 2 and 3.
4. When the scanner finds an active
frequency, you can do one of the
following:
Store the frequency into the
current monitor memory —
quickly press
MONITOR
.
Lock out the frequency so the
scanner does not stop on it
again — press
S/S
. The scan-
ner resumes searching.
20-418.fm Page 20 Wednesday, August 4, 1999 12:42 PM

Table of Contents

Related product manuals