28
of the channels within the banks you
have turned off.
Notes:
• You cannot turn off all banks.
There must be at least one active
bank.
• You can manually select any
channel in a bank, even if the
bank is turned off.
To turn on banks while scanning,
press the bank’s corresponding num-
ber key until the bank’s number ap-
pears.
MANUALLY TUNING A
FREQUENCY
1. Press
TUNE
.
2. Use the number keys to enter the
frequency.
3. Press
ENTER
.
4. Press
▲
to move up one tuning
step. Press
▼
to move down one
tuning step. To move up or down
in 1 MHz increments, press
FUNC
then
▲
or
▼
.
To save the frequency into a
channel (bank 9 only), press
FUNC
then
ENTER
.
Stored @
9xx
appears (
xx
channel num-
ber).
When the scanner stops on a frequen-
cy while searching, press
FUNC
then
TUNE
.
Notes:
• You cannot change the step fre-
quency while tuning.
• You can change the receiving
mode while tuning.
DELETING
FREQUENCIES FROM
CHANNELS
1. Press
MAN
.
2. Use the number keys to enter the
channel containing the frequency
you want to delete.
3. Press
MAN
again.
4. Press
PROG
to enter the program
mode.
M
changes to
P
on the dis-
play.
5. Press
FUNC
.
6. Press
CLEAR
. The frequency
number changes and the display
shows
0.0000 MHz
.
LISTENING TO THE
WEATHER BAND
The FCC (Federal Communications
Commission) has allocated channels
for use by the National Oceanic and
Atmospheric Administration (NOAA).
Regulatory agencies in other coun-
tries have also allocated channels for
use by their weather reporting authori-
ties.
20-196a.fm Page 28 Friday, June 2, 2000 3:48 PM
To Next Page
Loading...
