9
Follow these steps to power the transceiver from AC
power.
1. Using the double-sided foam tape supplied with
the cigarette lighter accessory outlet, mount the
accessory outlet to the DC power supply.
2. Insert the power cord’s barrel plug into the trans-
ceiver’s
DC13.8V CHARGE
jack.
Note:
If you installed rechargeable nickel-cad-
mium batteries in the transceiver, connect the
power cord to the
DC13.8V CHARGE
jack and be
sure the
NI/AL
switch is set to
NI
. This powers
the transceiver and recharges the batteries at
the same time. See “Charging Nickel-Cadmium
Batteries.”
3. Insert the cigarette lighter plug on the DC power
cord into the cigarette lighter accessory outlet.
4. Connect the DC power supply to a standard AC
outlet.
21-1678.fm Page 9 Thursday, August 5, 1999 12:45 PM
To Next Page
Loading...
