TRS-80 MODEL III
RESET
RESET
is
the orange-colored button at the upper right corner
of
the keyboard.
To'
'startover" at the power-on message, you do not have to tum the unit
off
and
on again. Pressing the
RESET
button will have the same effect.
Note: Resetting the Computerdoes not erase the contents
of
RAM.
However, the
BASIC language interpreterwill start over,
thus'
'losing" any program ordata you
had in memory.
To interrupt a program
or
operation without losing yourBASIC program and data,
hold down the
(BREAK)
key.
Power-Off
First
tum
off
the Computer, then all other peripherals.
If
you
tum
the Computer
off
for any reason, leave it
off
for at least
15
seconds before
turning it back
on
again. The Computer's powersupply needs this time to discharge
its storedenergybefore starting up again.
Wheneveryou
tum
off
the Computer, all programs and data are erased. So be sure
to save yourinformation (e.g. , on cassette) before turning
off
the Computer.
Start-UpDialog
When you
tum
on
or
reset the Computer, it asks you two questions. First:
Cass?
This question lets you determine the rate at whichprograms and data will be
transferred to and from cassette. You can select eitherLow
(500 baud) orHigh (1500
baud). Type
L
for Low,
or
H
for High.
3/2
To Next Page
Loading...
