TRS-80 MODEL III
How to Searchfor a
Program
If
the tape contains different programs on the same side, you can make the
Computersearch through them until it reaches the desired program. To do this, just
specify the name
of
the program.
For
example,
if
the program is named
"P",
then
type in this command:
CLOAD"P"
(ENTER)
While the Computer is skipping a non-matching program, it will display the file
name
of
that program.
Note:
lfthe
program you named is not on the tape, the Computerwill continue to
wait for it, even afterthe tape has runout. Hold down the
(BREAK)
key until the
Computerreturns with the message:
READY
>
Recorder
User-Generated Pre-Recorded From
Model
Radio Shack
CTR-BO,
BOA
5-7
4-6
Figure2. Recommended levels for loading programs from
tape.
6/4
To Next Page
Loading...
