Loading
the
Program
If,
after writing or running other programs,
you
wanted to go back and
use this program again,
you
must "load" it back into memory. To do
this, type: LOAD "filespec", R
Example
LOAD
"AUTHOR",
R
(ENTER)
tells the computer
to
load the program "AUTHOR" from disk into
memory; option R tells the computer
to
run
it.
Another way
to
load
and
run
a program
is
to
type:
RUN
"filespec".
RUN
automatically loads
and
runs the program specified by
"filespec".
The SAVE, LOAD
and
RUN
commands are discussed
in
more detail
in
Chapter
7.
2-12
To Next Page
Loading...
