FORMS/FLT
Filter
SET
*FF
TO FORMS/FLT
FILTER *PR
*FF
You can use FORMS/FLT to prepare the printer filter (*FF) for use.
In
order to use the printer filter (*FF), you must SET it to this filter
program, and activate it with the FILTER command.
After you SET
*FF
to FORMS/FL
T,
you can set up the parameters of
the printer filter with the FORMS command.
Example
SET
*FF
TO
FORMS
I
FL
T
(ENTER)
sets
*FF
to its filter program.
FILTER
*PR
*FF
filters the printer to the printer filter program.
FORMS
(MARGIN=12,CHARS=70,INDENT=17)
(ENTER)
configures the printer filter by causing all lines to start 12 spaces
in
from the normal left-hand starting position. Any line longer than 70
characters is indented 17 spaces
(5
spaces past the margin) when
wrapped around, so it is printed starting at position
7.
Technical Information
When you set the FORMS/FL
T,
it will be placed
in
high memory if
there is not enough room
in
low memory. (Low memory is within
TRSDOS and does not take away from the memory available for your
programs.) If this happens, a message similar to the following
appears:
Note: filter installed
in
high memory.
If you want to use Memdisk while you are using FORMS/FL
T,
be sure
to install Memdisk first.
A-95
To Next Page
Loading...
