26
You cannot control
other Plug ’N Power
modules from your
remote control
(continued).
Make sure that you have power to
the AC outlet and the light or
appliance is on.
Plug another Plug ’N Power con-
troller and the modules into the
same AC outlet, then try to control
the modules again. If your control-
ler is the only one you have, use
an extension cord to plug the con-
trol center receiver and your other
Plug ’N Power module into the
same AC outlet. If the module still
does not work, replace the mod-
ule.
Symptom Suggestion
61-2576.fm Page 26 Wednesday, September 8, 1999 1:50 PM
To Next Page
Loading...
