22
REPLACING THE FUSE
If the detector stops operating, check the fuse in the DC
power cord’s cigarette-lighter plug. If it has blown, fol-
low these steps to replace it.
1. Carefully unscrew the tip of the cigarette-lighter
plug.
2. Remove the tip from the cigarette-lighter plug, then
remove the old fuse.
Note:
The tip is in two pieces. Take care not to lose
either piece or the spring inside the holder.
3. Replace the fuse with a 1-Amp, 5 × 20 mm, fast-act-
ing fuse (Cat. No. 270-1049).
Caution:
Using a fuse that does not meet these rat-
ings or defeating the fuse protection can damage
your detector or the vehicle’s electrical system.
4. Press the cigarette-lighter plug’s tip down into the
body, then screw it back in.
Caution:
Be sure you press the cigarette-lighter
plug’s tip down before screwing it in, or you might
damage the plug.
Tip
Holder
Fuse
22-1660.fm Page 22 Friday, August 6, 1999 9:38 AM
To Next Page
Loading...