RadioLink Electronic Ltd
www.radiolink.com
26
A560 (PNP) Instruction Manual
Disclaimer and Warning
Please refer to A560 RTF Disclaimer and Warning.
Packing List
Please refer to A560 RTF Packing List.
Chapter 1 General Introduction
Please refer to A560 RTF Chapter 1 General Introduction.
Chapter 2 A560 Assembly
2.1 A560 Assembly
Please refer to A560 RTF Chapter 2 A560 Assembly.
2.2 Receiver Connection
For A560 PNP version, transmitter and receiver needs to be installed. A560 is compatible to all
transmitters that supports SBUS/PPM signal.
1. First, install the receiver on A560 aircraft. Make sure the receiver is switched to SBUS/PPM
signal mode, and then connect the receiver to Byme-A V2.0 flight controller. For the connection
method of the receiver, please refer to A560 RTF Chapter 1.3.3 Flight Controller.
2. Second, calibrate the throttle range of A560 ESC. The normal Start-up and Throttle Range
calibration steps of A560 ESC are as follows:
For more information on how to use A560 ESC, please visit RadioLink official website:
https://www.radiolink.com/manuals_download
To Next Page
Loading...