RadioLink AT9S PRO - 2.3.5 SUB TRIM; 2.3.6 Servo Reversing (REVERSE)

24
2.6 Servo Reversing (REVERSE)
Changes the direction an individual servo responds to a CONTROL
STICK motion.
Except with CCPM helicopters, always complete your servo
reversing prior to any other programming. If you use pre-built
ACRO/ GLID functions that control multiple servos, such as
FLAPERON or V-TAIL, it may be confusing to tell whether the servo
needs to be reversed or a setting in the function needs to be
reversed. See the instructions for each specialized function for
further details.
Always check servo direction prior to every flight as an additional precaution to confirm proper model memory,
hook ups, and radio functions.
Caution: Always make sure servo of throttle in channel 3 is reverse and then charge the model. Do not
change the model type when it is charging. It may cause serious consequences if the throttle is not reverse.
Servo reversing
Goals
Steps
Inputs
Revere the direction
of the elevator
servo.
Open REVERSE function
for 1s .(If ADVANCE again)
to REVERSE, PUSH.
Choose proper channel and
set direction(Ex: ELEV
REV)]
to ELEV，
to REV，’Are you sure? displays
for 1s。
Close
2.7 Dual rates and exponential (D/R,EXP)
Dual/Triple Rates: reduce/increase the servo travel by flipping a switch, or (ACRO GLID) they can be
engaged by any stick position. Dual rates affect the control listed, such as aileron, not just a single (ex:
channel 1) servo. For example, adjusting aileron dual rate will affect both aileron servos when using
FLAPERON or AIL-DIF, and both aileron and elevator servos’ travel when using AILEVATOR or ELEVON or a
CCPM helicopter.
Activation:
• Any SWITCH, A-H. If you choose a 3-position switch, then that dual rate instantly becomes a triple rate.
Adjust the flap
servo’s SUB TRIM
until its center
exactly matches the
aileron servo’s
center as they work
together as
FLAPERON.
Open BASIC menu, then open
SUBTRIM
for 1s .(If ADVANCE again)
to SUB-TRIM
Choose the channel to adjust
until surfaces match(Ex: flap)
to FLAP，PUSH， as needed to each
channel.
Repeat for other channels
as needed.
Close
【REVERSE】
1：AILE
NOR
CH1：AILE
REV NOR
CH9: NOR
CH10: NOR
CH11: NOR
CH12: NOR
2：ELEV
NOR
3：THRO
NOR
4：RUDD
NOR
5：GEAR
NOR
6：FLAP
NOR
7：AUX1
NOR
8：AUX2
NOR