RadioLink AT9S PRO - PART 4 GLIDER MODEL FUNCTIONS; 4.1 SET BASIC MENU OF GLID; 4.3 GLID ADVANCE MENU

53
Goals
Steps
Inputs
Set up a
GYA gyro
setting
(Ex:MIX-1)
Open GYRO-SENSE
to BASIC . again to ADVANCE
to GYRO-SENSE,
Activate the function.
to MIX-1.PUSH to ON.
Optional: change switches
assignment.
Ex: select E.
to SW.PUSH. to SwE
Adjust gyro rates as needed.(Ex: UP
to NOR70%,CNTR to 0%[off], DOWN
to AVC70% as starting points.
to gyro rate. Push. E up. to NOR 70%，
E to CNTR, to 0%， E DOWN， to
AVC70%
Close
3.1.12 THR CURVE (ACRO)
This function adjusts the throttle operation curve for optimum the
engine speed to throttle stick movement.
Note: If the throttle EXP function is activated, you can not use
THR-CURVE function simultaneously.
Adjustability:
• Separate curves for each switch position are available.
• Moving and deleting the curve point: The curve point (-STK-) can
be moved to the left or right by turning the DIAL (up to 2% in front of
the adjoining point) and deleted/returned by pressing the DIAL for one second alternately.
Goals
Steps
Inputs
Base point: Adjust base point of
throttle curve until engine idles
reliably.
-Out-:output,servo position.
-STK-: curve point, stick position.
Open THR-CURVE
to BASIC . again to ADVANCE
to THE-CURVE,
Activate the function.
to MIX.PUSH to ON.
Adjust the 1
st
point
to P1(-out-).PUSH to desired
servo position
Optional: assign the switch.
to SW.PUSH， to desired switch.
Optional: Move the curve
point.(Ex: point 3)
to P3 (-stk-),PUSH to desired
curve point to move to left or right.
Optional: delete the curve
point. And return the curve
point.(Ex: point 3)
to P3 (-stk-). for 1sec.to delete
the curve point.
to P3 (-stk-)， for 1sec.to return
Adjust the next point.
Repeat as needed.