RadioLink AT9S PRO - ELEV-FLAP Mixing; Spoiler MIX (Glid)

深圳市乐迪电子有限公司
www.radiolink.com
61
• Condition: The separate AILE RUDD setting for each flight condition can be set.
Goals
Steps
Inputs
Ex:RUDD-AILE,2
5%,no switch,
corrects roll
coupling.
Open AIL/RUD-MIX
submenu.
to BASIC . again to ADVANCE
to AIL/RUD-MIX,
Select the mixing mode.
to MODE ， to RUDD-AILE
Activate the function
to MIX ， to ON
Set the rate (Ex:100%
each way)
to RATE
RUDDER STICK ， to +25%
RUDDER STICK ， to +25%
Close
3.2.8 ELEV-FLAP mixing
The setting of ELEV-FLAP mixing of glider is the same with that of acrobasic. Click here or go to page 48 to
check the detailed setting method.
3.2.9 SPOILER MIX (GLID)
Moves the spoiler by flipping the assigned switch and is used to
make steep decent. SPOILER MIX works linking with BUTTERFLY
MIX.
Adjustability:
• Position: -100% to +100%, with a default of -50% (off), +50% (on)
• Channel: Spoiler 1: ch8, or 3 (ch8 or 3*), Spoiler 2: NULL, or 3
(NULL or ch3*) *GLID (2A+2F) mode.
• Elevator setting: Rate: -100% to +100%, Delay: 0% to 100%
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be
assigned.
Goals
Steps
Inputs
2-servo spoiler
mode. Adjust the
Open the SPOILER MIX
function and move to 2
nd
page.
to BASIC . again to ADVANCE
to SPOILER - MIX,