LCD Screen
When you power on the transmitter, LCD screen shows
battery
voltage,
R/C
control
system
name, model name,
steering
trim,throttle trim
Model Name
can store the data for 10 models, model name will show on the LCD when
you power on the transmitter. Please make sure the model name the screen displayed
is the right what you want. If the model name you chose is not corresponding with
your model, the pre-settings should be wrong.
Transmitter battery voltage
In addition to the model#, LCD can show the voltage of battery. When the
voltage is lower than 4.6V, it would start the low-voltage alert, it would send out
“BeBe…” sounds, till the transmitter is power-off. When you hear the low-voltage
alert, you have no more than 4 minutes for controlling your model, please safely stop
your model before the uncontrolled situation. Please make sure the battery voltage is
higher than this voltage data while radio controlling.
Transmitter function menu setting
When you want to browse or change a setting of transmitter, you should go into
function menu setting mode. Under function menu setting mode, you can set up
Language Select "LANGUAGE"
, Model Select
"MODEL", End Point Adjuster "EPA",
Steering EXP "STEXP", Steering Speed "STSPD", Throttle EXP "THEXP", Throttle
Speed "THSPD", A.B.S. Function "A.B.S", Throttle Acceleration "ACCEL", Idle-Up
"IDLUP", Subtrim "SUBTR", Servo Reverse "REV", Steering Dual Rate/Second
Dual Rate "D/R", ATL Function "ATL", Programmable Mixes "PMIX", Auxiliary
Channel 3 and 4 "AUX"，Model name "NAME", Reset function "RESET".
,the red light flashes two times
The system
8
To Next Page
Loading...
