RadioLink RC3S - Low Voltage Alarm; Reset Function RESET

Lower volt
ondepands
it
adjustable,
31
3.After accomplish ment of naming,all characters of current name will stop blinking,
the new namewill be stored automatically.
4.When ending setting,return to the initial screenby pressing“Exit” button twice.(the
new setting model name will appear on the initial screen)
The transmitter’s low voltage alarm
󰾡 battery,
the 4.6V
is may cause the battery over discharge
and
damage the battery.So
you can set transmitter’s
warning
voltage when
you use different battery.
There are four options you can choose:
Li2S-7.2V
Li3-10.8V
Ni4S-4.6V
CUSTOM: adjustable 4.6V to 12.0V.
REST- Data reset function:
All the data for any model memory can be reset to original factory defaults.Often this
function is done to get a “fresh start” and clear the memory before inputting new
model settings.
1.Enter the function menu and use “Dec(-)” or “Inc(+)”
button to access RESET function.
2.Press “Enter” button to get into RESET function
interface, the symbol “YES” will blink.
Reset function "RESET"
Low battery voltage alarm
The car will be out of control if the battery runs out,
please immediately stop running
when the alarm starting to ring.
what kind of
for 1s Lithium battery.