RADIOMETER TCM3 - Page 90

2. TCM3
TCM3 and TCM30 Service Manual
Serial Output, Continued
Category C
(continued)
Event Mark (EM Package)
Transmitted when the alarm-off key is pressed.
Line ID: EM
Field ID: AO
Calibration Start (CS Package)
Transmitted when a calibration is started.
Line ID: CS
Field ID: None
Calibration End (CE Package)
Transmitted when a calibration is completed.
LineID: CE
Field ID: CO pO, Cal. value (XXX) mmHg/(XX.Y) kPa
CC pCO, Cal. value (XXX) mmHg/(XX.Y) kPa
JE Electrode current (pO2) at calibration (XXXX) pA
VE Electrode voltage (pCO:) at calibration (XXX.Y) mV
If the monitor is measuring only pO, or pCO, the field VE or IE, respectively, is
omitted.
Exit From Setup Program (SU Package)
Line ID. SU
Field ID: Same contents as for Line XS (category B)
Exit From AUX Program (FT Package)
Line ID: FT
Field ID: Same contents as for Line XF (category B)
In-vivo Calibration End (VC Package)
Transmitted when an in-vivo calibration is completed.
Line ID: VC
Field IC: Same contents as for Line XV (category B)
Continued on next page