16
Rudder does not move Rudder, linkage or servo damage Replace or repair damaged parts and adjust con-
trols
Wire is damaged or connections are
loose
Do a check of wires and connections, connect
or replace as needed
Transmitter is not bound correctly or
the incorrect model was selected
Re-bind or select correct model in transmitter
BEC (Battery Elimination Circuit) of the
ESC is damaged
Replace ESC
ESC switch is off Power on ESC switch
Controls reversed Transmitter settings are reversed Do the Control Direction Test and adjust controls
on transmitter appropriately
Motor or ESC overheats Blocked water cooler tubes Clean or replace water tubes
Motor power pulses
then motor loses power
ESC uses default soft Low Voltage Cut-
off (LVC)
Recharge boat battery or replace battery that is
no longer performing
Weather conditions might be too cold Postpone until weather is warmer
Battery is old, worn out or damaged Replace battery
Battery C rating might be too small Use recommended battery
Replacement Parts List
Part Number Part Descrip on
RGRB1205 Black Marlin Brushless RTR Boat
RGRB1230 Painted/Decorated hull
RGRB1231 2212/3500KV Brushless Motor
RGRB1232 Water-Cooling Motor Mount
RGRB1233 Brushless Motor Coupler
RGRB1234 20A Brushless ESC (Water-Cooled)
RGRB1235 11.1V 3S 1800mAh LiPo Ba ery w/ T-Plug
RGRB1236 2.4Ghz 2 Ch. Receiver
RGRB1237 2.4Ghz 2 Ch. Transmi er
RGRB1238 DC Balance Charger
RGRB1239 AC Power Supply for RGRB1238
RGRB1212 Canopy Latch
RGRB1213 Rudder Pushrod Set
RGRB1214 Rudder Assembly
RGRB1215 Prop Strut Set
RGRB1216 Equipment Mount Set
RGRB1217 Drive Sha Guide
RGRB1218 Propeller w/Drive Sha
RGRB1219 Propellers (3)
RGRB1224 Rudder Servo
To Next Page
Loading...