Rage Jetpack Commander - Propeller Replacement; Calibration Instructions; Replacement Parts

Calibration Instructions
2. Place the Jetpack on level ground, turn it on and pair with the
transmitter.
3. Move the left stick all the way down and the right stick all the way up.
Hold them there until the LED lights on the Jetpack stop blinking
and remain solid.
4. The calibration process is now complete and the Jetpack is ready
to take off.
Battery Notes
•
• Do not leave batteries in hot places such as an automobile in direct sunlight.
• Do not mix new and used batteries, or install used batteries in other equipment.
• Do not mix Alkaline, Standard (Carbon-Zinc), or Rechargeable (Nickel Cadmium) or
• (Nickel Metal Hydride) batteries.
• Do not reverse the polarity (positive and negative terminals) of batteries.
• For best results use type AAA batteries.
• Install only new batteries of the same type in your product.
• Batteries should be recycled or disposed of per state and local guidelines.
Replacement Parts
Warning:
Small parts，not for
children under 3 years old.
.ragerc.com or
call 800 622-7223 M-F 9:00-5:00 mountain time.
A
A
B
B
Propeller Replacement
1. The 4 propellers are not identical. Each propeller is labeled with an A
or B.
2. When replacing a prop, refer to the drawing to the right for correct prop
placement.
that it inhibits movement.
Item Number Description
RGR4510
Propeller Set (4) Black
RGR4511
Propeller Set (4) White
RGR4512
Replacement Motor (CW)
RGR4513
Replacement Motor (CCW)
RGR4514
2.4GHz Transmitter, Red
RGR4515
2.4GHz Transmitter, White
RGR4516
Combat Streamer Set (20)
RGR4517
Landing Pad
RGR4518
Stunt Hoop
RGR4519
USB Type Charger