11
Attention ! Never mow wet grass or wet .
Keep trimmer from hard surfaces and injuries.
3.3 Angle and direction of mowing Fig. (E) 3.4 Replacement Spool Fig . (C)
· Turn o the trimmer from the socket ;
· Turn machine cutting equipment upward ;
· Hold rmly with one hand propeller motor ( 1 ) . With the other hold the spool
holder ( 2 ) . Pull the blade out of the holder while the parts are separated .
· Replace empty spool ( 3 ) and clean the inside of the holder of the remnants
of grass and dust.
· Then put the new pulley and reassemble the parts in reverse order.
· Download of the twine to ensure proper placement of the reel.
· Replace the cord just the same kind of brand “RAIDER”
4 . Practical tips:
4.1. Follow local regulations for the time of day during which you can use
machines outdoors. In some countries prohibit mowing morning before 08.00
hours, in the afternoon between 2:00 p.m. to 16:00 hours and after 22:00 at night,
to protect citizens from unwanted noise.
4.2 . Often lawns are composed of grasses of dierent varieties . With frequent
mowing you will boost the growth of those species that form dense sod and strong
roots. If you mow your lawn frequently will strengthen and improve the development of high- growing grasses and weeds . The normal height
of the grass is about 4-5 cm. Better to plan the frequency of mowing a lawn that can reduce up to 1 /3 of the total height of the grass. If you
do not irrigate your lawn, mow grass lower than 4 cm, since a potential drought it will degenerate .
4.3 . When working in very dicult conditions not to overload the motor. When reloading the rotational speed of the motor drops and
noise is changed . In this case, stop, release the lever to include ( 1 ) and set higher mowing height . Otherwise, performance will be reduced
and the machine may be damaged .
4.4 . When cutting close to edges careful not to pinch trim foreign objects .
4.5 . Cutting performance depend on the density, moisture content, length of the grass and the cutting height . Cutting performance
decreases with frequent switching on and o of the trimmer during mowing . To optimize the performance of the cutting recommended
frequent cutting, increasing the height of the cutting operation and at a moderate speed .
5 . Servicing, maintenance and storage.
ATTENTION! Always disconnect the plug from the wall outlet before making activities related to maintenance or cleaning !
Once the machine is turned o, the cord continues to rotate for some time by inertia ! Before you start working on trimming wait rotation
of the motor and the cord to stop completely!
Never try to stop the rotation of the cord !
When you need to perform tasks near cord always operate with gloves !
Perform maintenance procedures regularly to ensure your long-term and reliable use of the trimmer . Periodically check for visible
defects such as loose or damaged knife and loosened screw connections . Make sure the covers and guards are undamaged and are
installed properly.
To Next Page
Loading...
