Need help?Do you have a question about the Rain Bird SI-RR and is the answer not in the manual?
General| Brand | Rain Bird |
|---|---|
| Model | SI-RR |
| Category | Recording Equipment |
| Language | English |
Ensure the 230V power supply is off before controller installation.
Remove terminal strip access door and front panel to access internal components.
Connect the radio interface pin plug to the circuit board connector.
Wire the pin plug using color codes and adjust cable length as needed.
The interface automatically identifies connected controller models (SI-RR-6, SI-RR-8, SI-RR-12).
Details channel operations for SI-RR-6: station control and program start.
Details channel operations for SI-RR-8: station control and program start.
Details channel operations for SI-RR-12: station control and program start.
Procedure to store up to 10 unique transmitter codes via push-button and command.
How to erase all stored transmitter codes using reset plates.
Use directional arrows for channel display and top/down arrows for ON/OFF commands.
Procedure to set the highest available channel number from 99.
Lock the keypad to prevent accidental presses by holding red and left arrow keys.
Configure green/red keys for direct access to a stored frequently used channel.
Use green key for ON and red key for OFF commands for stored channels.
LCD displays 'Lb' when battery level is low, requiring replacement.
Replace two AAA 1.5V batteries simultaneously, ensuring correct polarity.
External antenna can be wall-mounted or attached to the radio interface cabinet.
Disconnect internal antenna and connect external antenna cable to terminals.
Features 2 independent outputs with dry contact relays for various devices.
Outputs can be configured as Pulse, Timing, or Bistable command modes.
Instructions for wiring the 230V power supply to the universal receiver.
Connect relay output to push-button terminal, use pulse command mode.
Connect relay output parallel to switch, use bistable or timing mode.
Connect relay output parallel to push-button, use pulse command mode.
Assign channel and configure first output for pulse command mode.
Assign channel and configure second output for pulse command mode.
Chart detailing number of flashes to duration mapping for timing mode.
Configure first output duration and channel assignment in timing mode.
Configure second output duration and channel assignment in timing mode.
Assign channel and configure first output for bistable mode.
Assign channel and configure second output for bistable mode.
Procedure to disconnect power, press button, and reconnect to erase memory.
To Next Page