What to do if my Rain Bird STP6PL Network Router LCD display is blank?
If the LCD display on your Rain Bird Network Router is blank, check that the two-prong connector is connected and the transformer is securely plugged in. Also, ensure the main AC power supply is working properly.
What to do if the Rain Bird STP6PL Network Router LCD display is frozen and won't accept programming?
If your Rain Bird Network Router's LCD display is frozen and not responding to programming, the controller's electronics may have been damaged by an electrical surge. Unplug the controller for 3 minutes, then plug it back in. If there is no permanent damage, the controller should resume normal operation and accept programming.
Why won't my Rain Bird STP6PL Network Router start watering automatically or manually?
Several factors could prevent your Rain Bird Network Router from initiating watering cycles. First, ensure your main water line and all supply lines are open and functioning correctly. Verify that all field wires and master valve/pump start relay wiring are properly connected. Inspect field wiring for any breaks, cuts, or exposed wires, replacing them if necessary, and ensure all wire connections are watertight. Confirm the dial is set to the AUTO position. If a rain sensor is installed, it might be activated; wait for it to dry or disconnect it, replacing it with a jumper wire. If no rain sensor is installed, ensure the jumper wire connecting the yellow terminals is intact. Finally, an electrical surge might have affected the controller; press the Reset button to see if normal operation r...
Instructions for programming watering start times and durations for each zone.
Explains how to suspend watering for up to 72 hours due to weather.
Guides on connecting valve wires from each zone to the controller's terminal block.
Steps for connecting the power transformer and any accessories.
Common watering problems, their causes, and solutions.
Addresses issues like blank displays or frozen controllers and their resolutions.
Instructions for programming watering start times and durations for each zone.
Explains how to suspend watering for up to 72 hours due to weather.
Guides on connecting valve wires from each zone to the controller's terminal block.
Steps for connecting the power transformer and any accessories.
Common watering problems, their causes, and solutions.
Addresses issues like blank displays or frozen controllers and their resolutions.
General| Brand | Rain Bird |
|---|---|
| Model | STP6PL |
| Category | Network Router |
| Language | English |
To Next Page
