5 | POWER NOZZLE
Replacing the Power Nozzle
™
Belt
1. Turn the Power Nozzle upside down.
Using a flat-bladed screwdriver or coin,
turn the fastener a quarter-turn to the left
(counterclockwise).
2. Using both thumbs, push tabs on both sides
of sole plate outward while lifting to unlock.
3. Next, insert index fingers into two side
openings near wheels. Pull side tabs up
while pushing in to lift off sole plate.
4. Rotate brush roll assembly forward (note that
edge cleaning brushes are upside down) and
remove.
5. a) Slide worn or broken belt off motor shaft
with finger; b) Lift brush roll out and remove
worn belt.
6. Place new belt over the end of brush roll
assembly. Position new belt around the
pulley.
For best performance, we recommend you replace your Rainbow Power Nozzle belt every 12 to 18 months, or when you notice decreased cleaning
performance. Your Power Nozzle comes with one replacement belt, and can be easily changed in just a few minutes. This replacement belt is located in
the spare belt pocket under the sole plate. For additional replacement belts, contact an Authorized Rainbow Distributor.
!
WARNING: Always disconnect from electrical supply when servicing.
7. a) Place brush roll upside down with edge
cleaning brushes centered on top of two side
tabs. Slide belt over end of motor shaft; b)
Rotate brush roll assembly forward until edge
cleaning brushes are face up. Spin brush roll
toward you to position the belt on the center of
the pulley.
8. Position sole plate over top of Power Nozzle
cover. Press down until front, two side tabs and
back tabs snap and lock in.
9. Using a flat-bladed screwdriver or coin, turn the
fastener a quarter-turn to the right (clockwise)
to lock sole plate. Assembly is complete.
To Next Page
Loading...