Need help?Do you have a question about the RAISE 3D E2 and is the answer not in the manual?
General| Print Technology | Fused Filament Fabrication (FFF) |
|---|---|
| Extruder Type | Dual Extruder |
| Nozzle Temperature | Up to 300°C |
| Bed Temperature | Up to 110°C |
| Print Speed | Up to 150 mm/s |
| Filament Diameter | 1.75 mm |
| Connectivity | USB, Ethernet, Wi-Fi |
| Camera | Yes |
| Dimensions | 607 x 596 x 465 mm |
| Build Volume | 330 x 240 x 240 mm |
| Nozzle Diameter | 0.4 mm |
| Supported Materials | PLA, ABS, PETG, TPU, Nylon, PC, Carbon Fiber |
| Touchscreen | 7-inch |
| Build Plate | Removable, flexible build plate |
| Power Requirements | 100-240V, 50/60Hz |
| Operating System | Raise3D OS |
Lists and describes the front components of the E2 3D printer.
Lists and describes the rear components of the E2 3D printer.
Details additional mechanical components of the E2 3D printer.
Specifies the operating environment conditions for the E2 printer.
Details how to connect the printer to a power source and ensure proper grounding.
Guides the installation process for the ideaMaker slicing software on Windows.
Guides the installation process for the ideaMaker slicing software on macOS.
Configures initial printer and filament settings within the ideaMaker software.
Demonstrates how to import models and start slicing using the ideaMaker software.
To Next Page
