Need help?Do you have a question about the RAISE 3D N2 and is the answer not in the manual?
General| Nozzle Temperature | Up to 300 °C |
|---|---|
| Frame Material | Aluminum |
| Display | 7-inch Touch Screen |
| Extruder Type | Dual Extruder |
| Filament Diameter | 1.75 mm |
| Print Speed | Up to 150 mm/s |
| Build Volume | 305 x 305 x 300 mm |
| Nozzle Diameter | 0.4 mm |
| Supported Materials | PLA, ABS, PC, TPU, Nylon, Carbon Fiber, Wood, Metal filled filaments |
| Connectivity | USB, Ethernet, Wi-Fi |
Turn the printer power switch to 'Off' and unplug the power cable.
Remove the printer's back panel and attached side door using a Phillips head screwdriver.
Remove four fixing screws with a 2mm hex wrench to open the electronic box cover.
Remove the covering for the wire-path behind the electrical box if present.
Pass the sensor cable through the wire path and feed it into the electrical compartment.
Connect the adapter cables to the Y+, Z+, and EXP3 ports on the motion controller board.
Connect the white sensor cable to the sensor and remove the tape covering.
Power on the printer and verify the red lights on the sensor are illuminated.
Replace original Bowden tubes with the included 4mm-OD tubes if necessary.
Insert guide tubes into the back cover and adjust the sensor height.
Load filament through the Run-Out Sensor and Bowden tube, checking the filament path.
Re-attach the wire-path covering, electronic box cover, and back panel.
Download and install the latest motion board and touchscreen firmware via USB.
To Next Page