SAFETY 249
Regular Cab Tether Anchorages (Behind Covers)
Crew Or Quad Cab Outboard Tether Anchorage
Crew Or Quad Cab Center Tether Anchorage With Head
Restraint In Raised Position
LATCH-compatible child restraint systems will
be equipped with a rigid bar or a flexible strap
on each side. Each will have a hook or
connector to attach to the lower anchorage and
a way to tighten the connection to the
anchorage. Forward-facing child restraints and
some rear-facing child restraints will also be
equipped with a tether strap. The tether strap
will have a hook at the end to attach to the top
tether anchorage and a way to tighten the strap
after it is attached to the anchorage.
Center Seat LATCH
Regular Cab, Quad Cab Or Crew Cab Full Bench
Rear Seat: No Lower Center LATCH Anchorages
Available
1 — Tether Anchor
2 — Tether Strap Hook
3 — Tether Strap To Child Restraint
WARNING!
Do not install a child restraint in the center
position using the LATCH system. This posi-
tion is not approved for installing child seats
using the LATCH attachments. You must use
the seat belt and tether anchor to install a
child seat in the center seating position.
Never use the same lower anchorage to
attach more than one child restraint.
Please refer to Ú page 250 for typical
installation instructions.
6
21_DS_OM_EN_USC_t.book Page 249
To Next Page
Loading...
