GETTING TO KNOW YOUR VEHICLE 77
TAILGATE REMOVAL
NOTE:
Removing the tailgate will disable the rearview
camera function.
To remove the tailgate, follow the instructions
below:
1. Disconnect the wiring harness for the rear
camera and or power locks (if equipped)
Ú
page 77.
2. Unlatch the tailgate and remove the support
cables by releasing the lock tang from the
pivot.
NOTE:
Make sure tailgate is supported when removing
support cables.
Locking Tang
3. Position the tailgate on a 45° angle.
4. Raise the right side of the tailgate until the
right side pivot clears the hanger bracket.
5. Slide the entire tailgate to the right to free
the left side pivot.
6. Remove the tailgate from the vehicle.
NOTE:
Do not carry the tailgate loose in the truck
pickup box.
Disconnecting The Rear Camera And
Remote Keyless Entry
1. Open the tailgate to access the rear
camera or Remote Keyless Entry
connector bracket located on the rear sill.
Connector Bracket
WARNING!
To avoid inhaling carbon monoxide, which is
deadly, the exhaust system on vehicles
equipped with “Cap or Slide-In Campers”
should extend beyond the overhanging
camper compartment and be free of leaks.
2
21_DS_OM_EN_USC_t.book Page 77
To Next Page
Loading...
