386 TECHNICAL SPECIFICATIONS
Torque Specifications
**Use only your authorized dealer
recommended lug nuts/bolts and clean or
remove any dirt or oil before tightening.
NOTE:
Dual wheels are flat mounted, center piloted.
The lug nuts are a two-piece assembly. When
the tires are being rotated or replaced, clean
these lug nuts at the interface between the
lug nut/bolt and the washer. Do not oil wheel
studs.
Two-Piece Lug Nut
Inspect the wheel mounting surface prior to
mounting the tire and remove any corrosion or
loose particles.
Wheel Mounting Surface
Tighten the lug nuts/bolts in a star pattern until
each nut/bolt has been tightened twice. Ensure
that the socket is fully engaged on the lug nut/
bolt (do not insert it halfway).
After 25 miles (40 km), check the lug nut/bolt
torque to be sure that all the lug nuts/bolts are
properly seated against the wheel.
Four And Five Lug Nuts/Bolts Torque Pattern
Lug Nut/
Bolt
Torque
Lug Nut/
Bolt Type
**Lug
Nut/Bolt
Size
Lug Nut/
Bolt
Socket
Size
130
Ft-Lbs
(176 N·m)
Cone
M14 x
1.50
22 mm
129
Ft-Lbs
(175 N·m)
Flanged
WARNING!
To avoid the risk of forcing the vehicle off the
jack, do not tighten the lug nuts/bolts fully
until the vehicle has been lowered. Failure to
follow this warning may result in personal
injury.
19_DJD2_OM_EN_USC_t.book Page 386
To Next Page
Loading...
