MULTIMEDIA 63
The Shift Light RPM Set-Up allows you to set the
Shift Light to illuminate for gears 1, 2, 3, 4, and
5-8. Pressing and releasing the Up/Down arrow
buttons above and below each listed gear, the
RPM values will change in increments of 250 RPM.
Pressing and holding the arrows will change the
RPM values in increments of 500 RPM, up to
6250 RPM. Press the Reset to Factory Default
button on the touchscreen to change back to
factory settings, or press the Deactivate Shift Light
button on the touchscreen to turn the system
off completely.
Race Cooldown — If Equipped
Race Cooldown is a selectable After-Run
Cooling feature.
Race Cooldown is a feature activated by
selecting the Race Cooldown button under
the Race Options tab.
Race Cooldown Button
To enable this feature, the vehicle will check to
ensure the engine is off, the hood is closed, the
status of the battery and system are acceptable
and determine if cooling is required.
After completing an event that has generated a lot
of heat in the powertrain, this feature helps cool
the vehicle after the engine has been shut down.
The radiator fan and low temperature radiator
coolant pump remain on after engine shutdown for
a period up to five minutes or until target
temperature is reached.
5
23_DT_TRX_SU_EN_USC_t.book Page 63
To Next Page
Loading...
