Installation Steps
NOTE: Actual application may vary slightly from illustrations.
Page 7 of 11
4-Door Model ONLY Locate the ceiling adjustment straps at the corners of the ceiling panel. Wrap the straps around the roll bar and
seatbelt stud toward the inside of the Jeep, then back up to the strap adjustment buckle.
Tighten and repeat for the passenger side. Adjust each side to position the top evenly. See diagram below:
2-Door Model ONLY Locate the ceiling adjustment straps at the corners of the ceiling panel. Wrap the straps around the roll bar and tub
top rail toward the inside of the Jeep, then hook the strap adjust buckle.
Tighten and repeat for the passenger side. Adjust each side to position the top evenly. See diagram below:
31
32
To Next Page
Loading...
