Rancilio Silvia E User Manual

Copyright 2007-2016, Auber Instruments Inc. All Rights Reserved.
No part of this manual shall be copied, reproduced, or transmitted in any way without the prior, written consent of Auber Instruments. Auber Instruments retains the exclusive rights to all information included in this
document.
Supplem entalInstallationGuideforSilviaE
KIT‐RSRTDNb
(April2016)

ThisisasupplementalguideforRancilioSilviaE,releasedonthewinterof2015forEuropeanmarket.
SincethechangesofSilviaEareverylimitedfromSilviaV4,thisguideonlycovertheinstallationsteps
thatneedtobeadjustedduetothesechanges.
Theonlydifferenceis
thatthetappingofpowerisdifferent.ThemainpowerswitchoftheSilviaEhas
changedfromtheoriginalmechanicalON/OFFswitchtoapushbuttonresetswitch.Therefore,wehave
totapthepowerfromthebrewswitch.
Usershouldstilluse“KIT‐RSRTDNInstallationguideV2.2”as
themaininstallationguide.

1. TappingthePowertotheController
ReplacetheoriginalbrewthermostatwiththeRTDStat(pointedbythebluearrowinFigure1).Thenwe
willtaptwocablesonthebrewswitch(pointedbygreenarrowsinFigure1)tosupplypowertothe
controller.Thegreenarrowspointtoaredandablackcableconnected
tothelowertwobladesonthe
brewswitch.


Figure1.Cablesneedtobetappedarepointedbygreenarrows.

First,removeallfourcablesonthebrewswitch.Connectthetwoblackcableswithpiggyback
connectorstotheredandblackcableremovedfromthebrewswitch.

Rancilio Silvia E Specifications

General

Boiler Type	Single Boiler
Boiler Material	Brass
Pump Type	Vibratory
Body Material	Stainless Steel
Weight	14 kg
Power	1100 W
Boiler Capacity	0.3 liters
Pump Pressure	15 bar
Portafilter Size	58 mm
Water Reservoir Capacity	2 liters
Dimensions	290 x 235 x 340 mm
Type	Semi-Automatic
Water Tank Capacity	2 liters
Voltage	230 V