Rancilio STILE - Doser Grinder Maintenance Procedures; Troubleshooting Guide

STILE_05.2022
STILE_05.2022
21
/
2
8
2
0
/
2
8
STILE
STILE
EN
EN
STILE
STILE
EN
EN
5.1.2 Check of condition of the power cable
FOR EVERY NEW USE: check the power cable.
• Before connecting the plug to the
power socket, check visually and by
touch that the protective sheath of
the cable is intact, that the wires are
not exposed and that the plug is not
damaged.
WARNING! If the power supply
cable is damaged in any way,
have it replaced by a specialised
technician.
1
0
5.1.3 Thorough cleaning of the grinders
EVERY MONTH: Clean the grinders with a suitable product (e.g. Grindz ™ Grinder
Cleaner) following the instructions on the package
5.1.4 Temporary decommissioning
If the appliance is to be set aside for a relatively long period of time, it is recommended
that you perform the following operations to keep it in good condition and avoid possible
problems the next time you restart it.
WHEN NECESSARY: cleaning the appliance and setting it aside.
• Carefully clean the coff ee grinder as
instructed in section 5.1.1.
• Thoroughly clean the grinders as
instructed in section 5.1.3.
• Unplug the cable from the power socket
and wind it around the appliance.
• Cover the appliance with a tea towel to
protect it against dust and dirt.
• Store the appliance in a dry, safe and
secure place.
1
0
5.1.5 Replacement of the grinders
WARNING! The grinders must be replaced by a specialised technician.
5.1.6 Final decommissioning
If the appliance is to be permanently decommissioned, empty the hopper of any coff ee,
remove the plug from the socket and cut the power cord.
Finally, pack the coff ee grinder using cardboard or other types of packaging and deliver
the appliance to a collection centre authorised to dispose of electronic waste as indicated
in chapter "7.2 - Disposal"
6 TROUBLESHOOTING
Fault Cause Solution
The doser grinder
does not turn on.
Lack of power. • Make sure that the power plug is
correctly inserted in the socket;
• Make sure that the switch is in the “I”
(ON) position;
• Make sure there is mains power and that
the circuit breaker and the main switch
are switched on.
• Check the condition of the power cord
and plug. If damaged, have them
replaced by a qualifi ed technician.
The doser grinder
starts but does
not grind coff ee.
Feed hopper
empty.
• Load the hopper with the coff ee beans to
be ground.
Closed shutter. • Open the shutter to allow the coff ee beans
to descend into the grinding chamber.
The appliance
does not start the
grinding cycle
when the keys
, ,
or the microswitch
are pressed (see
section 4.2.2).
The hopper is
not correctly
positioned
and the safety
microswitch
in the body of
the appliance
prevents the
motor from
starting.
• Correctly position the feed hopper making
sure to couple it perfectly to the body
of the appliance to activate the safety
microswitch and enable the motor to
function.