Rancilio STILE - Installation Procedure; Getting Started with the Doser Grinder; Preparation for Doser Grinder Use

STILE_05.2022
STILE_05.2022
9
/
2
8
8
/
2
8
STILE
STILE
EN
EN
STILE
STILE
EN
EN
1
2
1
Fig. 2 Fig. 3
3 INSTALLATION
To start using your new doser grinder, simply:
• Place the appliance on a solid surface away from splashing water and heat sources.
• Make sure that the voltage of the electrical power supply meets the power supply
requirements and that the electrical capacity of the system is suffi cient to withstand
the power absorbed by the appliance (see the product identifi cation label on the
bottom of the doser grinder).
• Make sure that there is a socket near the point of installation for electrical connection of the
appliance in compliance with the domestic regulations in force.
WARNING! The socket must be equipped with an effi cient earthing system.
WARNING! The electrical power supply system must also be equipped with a
circuit breaker upstream of the socket, in a known position that the operator can
reach easily, in order to protect the appliance against overloading and sudden
changes in voltage and the user against the risk of electric shock.
• Connect the plug of the power cable to the wall socket in the place of use;
•
If the use of power adapters, multiple sockets or extensions cannot be avoided,
it is mandatory to use products that comply with the domestic certifi cation
standards in force.
• If present, set the circuit breaker located upstream of the power socket to the “ON”
position.
• Turn the power switch of the appliance to the "I" position.
At this point the doser grinder is powered and ready to be used.
4 USING THE DOSER GRINDER
4.1 Preparation for use of the doser grinder
To load the coff ee beans, you need to:
• Turn on the doser grinder by turning
the power button (detail 1) to the “I”
(ON) position.
• At this point the doser grinder is
ready to be used.
1
Fig. 4