R&S FSVA3000 Series - Configuring Bandwidth and Sweep Settings

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
891User Manual 1178.8520.02 ─ 01
CALCulate<n>:MARKer<m>:FUNCtion:STRack:THReshold <Level>
This command defines the threshold level for the signal tracking process.
Note that you have to turn on signal tracking before you can use the command.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<Level>
Range: -130 dBm to 30 dBm
*RST: -120 dBm
Default unit: DBM
Manual operation: See " Signal Tracking " on page 364
CALCulate<n>:MARKer<m>:FUNCtion:STRack:TRACe
<TraceNumber>
This command selects the trace on which the largest signal is searched for.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<TraceNumber> 1 to 6
Range: 1 to 6
*RST: 1
Manual operation: See " Signal Tracking " on page 364
14.7.2 Configuring Bandwidth and Sweep Settings
The commands required to configure the bandwidth, sweep and filter settings in a
remote environment are described here. The tasks for manual operation are described
in Chapter 8.5, "Bandwidth, Filter and Sweep Configuration", on page 376.
● Configuring the Bandwidth and Filter....................................................................891
● Configuring the Sweep..........................................................................................894
14.7.2.1 Configuring the Bandwidth and Filter
[SENSe:]BWIDth[:RESolution].........................................................................................892
[SENSe:]BANDwidth[:RESolution]................................................................................... 892
[SENSe:]BWIDth[:RESolution]:AUTO...............................................................................892
[SENSe:]BANDwidth[:RESolution]:AUTO..........................................................................892
[SENSe:]BWIDth[:RESolution]:RATio............................................................................... 892
[SENSe:]BANDwidth[:RESolution]:RATio..........................................................................892
[SENSe:]BWIDth[:RESolution]:TYPE................................................................................893
[SENSe:]BANDwidth[:RESolution]:TYPE.......................................................................... 893
Setting Basic Measurement Parameters