Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
889User Manual 1178.8520.02 ─ 01
Parameters:
<Span> The minimum span for measurements in the frequency domain
is 10 Hz.
Range: 0 Hz to fmax
*RST: Full span
Default unit: Hz
Manual operation: See " Zero Span " on page 123
See " Span " on page 362
See " Zero Span " on page 363
See " Last Span " on page 363
[SENSe:]FREQuency:SPAN:FULL
This command restores the full span.
Manual operation:
See " Full Span " on page 362
[SENSe:]FREQuency:STARt
<Frequency>
This command defines a start frequency for measurements in the frequency domain.
Parameters:
<Frequency> 0 to (fmax - min span)
*RST: 0
Default unit: HZ
Example:
FREQ:STAR 20MHz
Manual operation: See " Frequency Sweep " on page 122
See " Start / Stop " on page 362
[SENSe:]FREQuency:STOP <Frequency>
This command defines a stop frequency for measurements in the frequency domain.
Parameters:
<Frequency> min span to fmax
*RST: fmax
Default unit: HZ
Example:
FREQ:STOP 2000 MHz
Manual operation: See " Frequency Sweep " on page 122
See " Start / Stop " on page 362
14.7.1.2 Configuring Signal Tracking
When signal tracking is activated, the maximum signal is determined after each fre-
quency sweep and the center frequency is set to the frequency of this signal. Thus with
drifting signals the center frequency follows the signal.
Setting Basic Measurement Parameters
To Next Page
Loading...
