Need help?Do you have a question about the R&S NRP33S and is the answer not in the manual?
General| Brand | R&S |
|---|---|
| Model | NRP33S |
| Category | Accessories |
| Language | English |
Provides safety information for using the R&S NRPxxS(N) and general safety instructions.
Details specific operating conditions required for accurate measurements and to avoid sensor damage.
Outlines options for connecting the power sensor to a computer via host or LAN interface.
Details how to connect the R&S NRPxxS(N) to a computer using the host interface via USB.
Explains how to connect the sensor to a LAN network and configure its LAN interface.
Explains the meaning of different indications of the status LED on the power sensor.
Describes the LAN PoE interface, its requirements, and risks of sensor damage.
Describes the integrated browser-based GUI for LAN power sensors, requirements, and setup.
Describes methods for updating the firmware, including risks of faulty firmware.
Details possibilities for controlling measurements, such as starting, cycles, and outputting results.
Describes settings needed for configuring different measurement modes.
Explains the process of zeroing the power sensor to remove offset voltages.
Explains the structure of SCPI commands, including headers, parameters, and queries.
Explains how the status reporting system stores and queries operating state and error information.
To Next Page
