Need help?Do you have a question about the R&S RT-ZC31 and is the answer not in the manual?
General| Category | Accessories |
|---|---|
| Type | Current Probe |
| Output Voltage | 10 mV/A |
| Connector | BNC |
| Attenuation | 1:1 |
| Input Impedance | 1 MΩ |
| Cable Length | 1.5 m |
| Compatibility | R&S oscilloscopes |
Overview of the R&S RT-ZC31 clamp-on current probe.
Highlights of the R&S RT-ZC31 current probe's capabilities.
Guide for checking the contents of the R&S RT-ZC31 package.
Detailed explanation of the R&S RT-ZC31 probe components.
Steps to prepare for measuring with the R&S RT-ZC31 probe.
Procedure for demagnetizing and zeroing the R&S RT-ZC31 probe.
Instructions for connecting the R&S RT-ZC31 probe to the device under test.
Steps for safely disconnecting the R&S RT-ZC31 probe.
Guide for accurate current measurement using the R&S RT-ZC31 probe.
Explanation of the R&S RT-ZC31 probe's protection mode and how to exit it.
Presentation of typical performance characteristics of the R&S RT-ZC31 probe.
Identifies potential errors and issues with the R&S RT-ZC31 probe.
Explains error indications based on the R&S RT-ZC31 probe's LED status.
Instructions for cleaning the R&S RT-ZC31 probe.
Information on how to get technical support for the R&S RT-ZC31 probe.
Guidelines for returning the R&S RT-ZC31 probe for service.
Recommended calibration frequency for the R&S RT-ZC31 probe.
Guidance on the proper disposal of the R&S RT-ZC31 probe.
To Next Page
