To Next Page

To Previous Page

Measuring Procedure

R&S

RT-ZC31

31User Manual 1801.4949.02 ─ 01

The DEMAG / AUTO ZERO LED lights up, and automatic zero-adjustment is

performed alone. After the completion, the DEMAG / AUTO ZERO LED goes

out.

6. Measure a current.

3.6 Protection Mode

To protect the device against self-generated heat, it enters protection mode when

the temperature of the junction box exceeds a specified level.

In protection mode, the device cannot correctly measure any current. Moreover,

you cannot switch the current ranges. If the device has entered protection mode,

recalibrate it because internal components may have been subjected to thermal

stress.

To exit the protection mode

1. Pull the opening lever toward you. Remove the device from the conductor that

you measure.

2. Slide the opening lever toward the lower jaw until the JAW UNLOCKED indi-

cator is hidden.

Protection Mode

Questions and Answers:

Need help?

Do you have a question about the R&S RT-ZC31 and is the answer not in the manual?

R&S RT-ZC31 Specifications

General