Ranger Communications RCI-2970N2

Need help?

Do you have a question about the Ranger Communications RCI-2970N2 and is the answer not in the manual?

Summary

Introduction and Installation

Transceiver Mounting and Power Connection

Guidelines for mounting the unit and connecting its power supply.

Chapter 4 Operation - Front Panel Controls Part 1

Frequency, Power, Gain, and Volume Controls

Describes controls for frequency, output power, mic gain, and audio volume.

Squelch, RF Gain, Clarifier, and Mode Selection

Explains controls for noise reduction, receiver gain, fine-tuning, and operating modes.

Noise Blanker and Roger Beep Functions

Details the operation of the noise blanker/limiter and roger beep features.

Chapter 4 Operation - Front Panel Controls Part 2

Split Frequency, Programming, and Manual Buttons

Shift, Dim, Scan, Memory, and Enter Buttons

Lock and Up;Down Selector Buttons

Chapter 4 Operation - Rear Panel and Microphone

Rear Panel Connectors and Ports

Microphone Operation and Wiring

Chapter 4 Operation - Frequency and Mode Details

Frequency Selection Methods

Mode Selection and RF Power Control

Chapter 5 Programming - Scanning and Memory

Receive Scanning and Split Frequency Setup

Memory Function and Programming Steps

Memory Channel Scanning Procedure

Chapter 5 Programming - Metering and Scanning

Memory Channel Scanning and Metering Overview

Chapter 6 Frequency Scanning

All-Frequency Scanning Configuration

Frequency Scanning - Memory Operation

Memory Scanning Procedure

Chapter 7 Offset Frequency Operation

Programming Transmit Offset Frequency

Detailed steps to program TX offset for FM repeaters.

Ranger Communications Limited Warranty

Warranty Terms and Conditions

Explains the 2-year limited warranty coverage and exclusions.

Memory Scanning - Addendum Details

Scanning Programmed Memory Locations

Initiating and Managing Memory Scan

Important Safety Information

Amateur Radio License Requirement

Warning regarding FCC license necessity for operation in the USA.