Ransburg RansFlex RFX 80365

Questions and Answers

L
Larry GonzalezAug 8, 2025
Why is there no kV in my Ransburg RansFlex RFX 80365 Paint Sprayer?
- J
  Jamie HollowayAug 9, 2025
  Several factors can cause a lack of kV in your Ransburg Paint Sprayer. It could be due to: * The On/Off lever being in the wrong position: Ensure it's in the On position. * Low pressure: Make sure there's 2.8 bar (40 psig) at the applicator handle when triggered. * No ground connection: Verify the air hose is properly grounded. * Cascade malfunction: Confirm the cascade is functioning correctly, swapping parts if needed. * Motor failure: Ensure the motor is working properly. * Paint conductivity: Confirm the paint resistance is greater than 0.1 Meg Ohm.
R
Robert SmithAug 15, 2025
What to do if there is no fluid flow in my Ransburg Paint Sprayer?
- T
  Teresa Smith MDAug 15, 2025
  If you're experiencing no fluid flow in your Ransburg Paint Sprayer, consider these potential causes and solutions: * No pressure: Ensure there is adequate pressure at the fluid line at the applicator. * Plugged fluid tube: Replace or clean the fluid tube. * Plugged fluid nozzle: Replace or clean the fluid nozzle. * Improperly assembled electrode: Reassemble and tighten the electrode to the stop. * Material too viscous: Thin the material to a sprayable viscosity.
D
Diane MaxwellAug 21, 2025
How to fix low kV in my Ransburg RansFlex RFX 80365?
- C
  Christine PriceAug 21, 2025
  Low kV in your Ransburg Paint Sprayer can often be resolved by addressing these issues: * Fluid remnants in the air passage: Clean the air passage with a non-polar solvent and ensure the fluid nozzle is properly tightened. * Using the wrong solvent for final cleaning: Always use a non-polar solvent for the final cleaning process. * Insufficient air pressure at the handle: Make sure there's 2.8 bar (40 psig) at the handle with the applicator triggered.
L
Lisa ClaytonAug 27, 2025
Why can't I adjust the fan pattern on my Ransburg RansFlex RFX 80365 Paint Sprayer?
- K
  kmoralesAug 27, 2025
  If you cannot adjust the fan pattern on your Ransburg Paint Sprayer, check the following: * Restrictor missing: Ensure the restrictor is in place. * Fluid nozzle too tight: Tighten the nozzle until it seats on the barrel o-ring, then add an additional 1/8 turn.
J
John HaynesSep 2, 2025
What causes poor atomization in a Ransburg RansFlex RFX 80365 Paint Sprayer and how to solve it?
- Q
  qpenaSep 2, 2025
  Poor atomization in your Ransburg Paint Sprayer can be caused by foreign particles in the atomization air passages. To resolve this, ensure that the atomization air passages are clear of all foreign particles.