What to do if Rapid Airtac PB131 staple jam occurs?
If a staple jam occurs in your Rapid Nail Gun, here’s what to do: First, disconnect the tool from the air supply. Release the magazine and slide the rail back to remove any jammed fasteners. Then, open the latch on the front cover and pull it out to remove the jammed projectile. Finally, replace the front cover and close the latch.
Details the physical dimensions and weight of the pneumatic nailer.
Specifies air inlet size and operating pressure limits for safe use.
Outlines compatible fasteners and the tool's loading capacity.
Provides guidance on lubrication and technical noise/vibration data.
Essential safety measures including personal protection and prohibited gas sources.
Guidelines for safe air supply connection, pressure, and disconnection procedures.
Procedures for safe tool handling, operation, maintenance, and parts usage.
Step-by-step guide for loading fasteners into the nailer.
Instructions on how to safely operate the pneumatic nailer.
Procedures for resolving common issues and performing maintenance.
Read these warnings to prevent injuries to yourself and bystanders.
Ensures proper use of safety glasses, ear protection, and clothing.
Guidelines for safe use of compressed air and prohibited gases.
Covers proper handling, trigger safety, and maintenance disconnect procedures.
To Next Page
General
