Rapid PMP171 - Page 91

91
instrumentului.
 -
-
nent. (Figura 2)
 -


 

 -
mentului pe un suport, de exemplu
pe masa de lucru, vor fi proiec-

stativului astfel încât instrumentul


daunelor, distorsiunii sau deplas-

 -
sirea instrumentului pot necesita


exemplu la lucrul în zone cu pericol
de explozie).
 -


 
parte a instrumentului cum ar fi

 

adecvate;
 
la intervale regulate în conformitate

 -
strumentului, de exemplu, prin:
- poansonare sau gravare;
-


realizate din materiale dure cum ar

-

- folosirea echipamentului ca un ci-


ÎNCĂRCARE
-
sa de aer comprimat. (Figura 3)

pârghiei. (Figura 4)



(Figura 5)


doar dispozitivele de fixare reco-

(Figura 6)




UTILIZARE INSTRUMENT
 

sursa de aer.
 
-


consumul de energie.
 


-
sar pentru penetrarea pieselor de

-
une. (Figura 7)