Display is not
switched on or not
operational
The power plug could be not properly
inserted into its socket.
Ensure that the power plug is now inserted properly
into its socket.
Ambient and cold
water is not served
The water supply might be disconnected.
Ensure that the unit is properly connected to a proper
water source and wait for at least 80min for the
water to cool to desired temperature.
Dispensed cold water
is not cold enough or
not at desired
temperature
The unit was just connected to a power
source.
Water is still in the process of cooling down and
being produced. Wait for 2 hours for initial startup.
Cold water had been dispensed in large
amounts previously or had been
dispensed frequently.
There is insufficient cold water in the unit and new
water from the source is being cooled down. This
process takes approximately 80 minutes.
Hot water is not hot
enough, or not at
desired temperature.
The hot water is switched off.
Turn on the heating switch.
There is no water in the hot water tank.
It takes a few minutes to fill up the tank and heat the
water to 85-95
°C
.
To Next Page
Loading...