The Development Kit contains the following:
1 × CMIO v3 breakout board
1 × CM3+/32GB Compute Module
1 × CM3+/Lite Compute Module
1 × CMCDA board (breaks in half to 1 × camera and 1 × display adapter)
2 × 22W, 0.5mm pitch, 50mm length small FFCs for the adapters
1 × USB B to USB A cable (for programming)
4 × pin header female-to-female jumper leads (20cm), to allow connecting display and
camera I2C
Note: a separate power supply, such as the official Raspberry Pi Universal Power
Supply, is required to power the product (not included in the kit).
The CM3+, CM3+/Lite, CM3, CM3 Lite, and CM1 are available for purchase in single
units, or in batches of hundreds or thousands.
COMPIANCE
The Compute Module Development Kit has undergone extensive compliance testing,
and meets the following European standards:
Electromagnetic Compatibility Directive (EMC) 2014/30/EU
Restriction of Hazardous Substances (RoHS) Directive 2011/65/EU
View and download global compliance certificates for Raspberry Pi products.
https://www.raspberrypi.org/products/compute‐module‐development‐kit‐2/2‐1‐19
To Previous Page
Loading...
Need help?
General
