Need help?Do you have a question about the Raspberry Pi RP2040 and is the answer not in the manual?
General| Processor | Dual-core Arm Cortex-M0+ |
|---|---|
| Clock Speed | 133 MHz |
| SRAM | 264 KB |
| GPIO | 30 |
| USB | USB 1.1 Host/Device |
| PWM | 16 channels |
| UART | 2 |
| SPI | 2 |
| I2C | 2 |
| Temperature Range | -20°C to +85°C |
| Operating Voltage | 1.8V to 3.3V |
| Flash | External QSPI flash |
| I/O Interfaces | SPI, I2C, UART, PWM |
| ADC | 4 × 12-bit ADC channels |
Steps to quickly set up your development environment for Raspberry Pi Pico, including script execution.
Instructions for downloading and cloning the Raspberry Pi Pico SDK and example repositories.
Steps to install necessary tools like CMake and the GNU Embedded Toolchain for Arm.
Steps to build, load, and run the 'Blink' example program on the Raspberry Pi Pico.
Explains how serial input/output works on the Pico via UART or USB CDC.
Steps to build, flash, and run the 'Hello World' example.
Instructions for installing OpenOCD, a debug translator for SWD.
Details on wiring the SWD port and loading programs via OpenOCD.
Creating a debug build and installing GNU Debugger (GDB) for interactive debugging.
To Next Page
