Raspberry Pi CM3+ User Manual



Compute Module Development Kit
The Compute Module Development Kit for developing industrial applications
GETTING STARTED
Quick-start guide
Please read this quick-start guide carefully before unpacking the boards from
their anti-static bags or using the kit: it contains important information on how to
avoid damage to the Compute Module and/or the CMIO Board.
Static sensitivity warning
Both the Compute Module and the CMIO board can be damaged by static electricity
(electrostatic discharge or ESD). Please take adequate precautions against static
discharge during handling.

Raspberry Pi CM3+ Specifications

General

Processor	Broadcom BCM2837B0
CPU Speed	1.2 GHz
RAM	1 GB LPDDR2
Dimensions	67.6mm x 31mm
GPIO	48 GPIO pins
Power	5V DC via GPIO header
Connectors	200-pin SODIMM connector
USB	USB 2.0
Audio Output	I2S
Storage	eMMC (Lite version has none)
Operating Temperature	-20°C to 70°C

Summary

Getting Started

Quick-start Guide

Read this guide before unpacking to avoid damage to the Compute Module and CMIO Board.

Static Sensitivity Warning

Warning regarding potential damage from static electricity (ESD) to the Compute Module and CMIO board.

Initial Setup and Checks

Steps for initial setup and checks, including inserting the CM, checking jumpers, and powering up.

Specifications

Compliance