Raspberry Pi Cooler

To Next Page

To Previous Page

Physical specication

WARNINGS

• This product should only be used with Raspberry Pi Compute Module 5.

• This product should be operated in a well-ventilated environment, and if used inside a case, the case should not be

covered.

• Make sure the metal cooler does not touch any electronic components on Compute Module 5 or any accessories, to

avoid the risk of unwanted electrical contact and shorting.

• Ensure the thermal pads are present and undamaged before use. If the pads are missing or damaged, you will need

to replace them before using the Cooler.

• Ensure the screws are undamaged and can screw into the Cooler securely before use. Discontinue use of the Cooler

and replace the screws if they are damaged or deformed, or if they do not screw in securely.

• Take care when using the Cooler, as the metal parts of the product may become hot during operation.

SAFETY INSTRUCTIONS

To avoid malfunction or damage to this product, please observe the following:

• Do not expose to water or moisture, or place on a conductive surface whilst in operation.

• Do not expose to heat from any source; the Raspberry Pi Cooler for Raspberry Pi Compute Module 5 is designed for

reliable operation at normal ambient temperatures.

4 × M2.5

102.7

Note:

All dimensions in mm

All dimensions are approximate and for

reference purposes only. The dimensions

shown should not be used for producing

production data

The dimensions are subject to part and

manufacturing tolerances

Dimensions may be subject to change