ratiotec RS 2200 - Additional Settings; Automatic Counting Features; Currency and Reset Options; Eco Mode

8
AUTO CONT: The auto continuation function permits the user to automatically count through all denomina-
tions, from lowest to highest, without having to use the < or > keys to move to the next denomination. ON is the
default setting.
To change or congure AUTO CONT, press OK when AUTO CONT is shown in the Setup Menu. Press < or > to
choose ON or OFF. Press OK to conrm your choice.
AUTO ADD: The AUTO ADD function allows the last total to be automatically added into a total sum after remo-
ving the amount from the scale. ON is the default setting. If this function is activated, AUTO ADD will appear on
the right side of the display followed by a check mark.
To change AUTO ADD, press OK when AUTO ADD is shown in the Setup Menu. Press < or > to choose ON or OFF.
Press OK to conrm your choice.
AUTO SAVE: The AUTO SAVE function allows the complete results of the last count to be automatically saved in
the scale’s memory, even if the scale is turned o. ON is the default setting.
To change AUTO SAVE, press OK when AUTO SAVE is shown in the Setup Menu. Press < or > to choose ON or
OFF. Press OK to conrm your choice.
CURRENCY: Use CURRENCY to select the desired currency. The RS  is pre-set to count USD, CAD and MXN.
The chosen currency will be shown on the display.
To change the CURRENCY, press OK when CURRENCY is shown in the Setup Menu. Press < or > to choose USD,
CAD or MXN. Press OK to conrm your choice.
RESET: Use RESET to reset all saved settings to the factory default, including calibration of the coin cup. To
change to RESET your device, press and hold OK when RESET is shown in the Setup Menu. The procedure is
nished when three audible beeps are emitted from the scale.
After resetting the device to factory settings, the scale will automatically run the CALIBRATE procedure descri-
bed above.
ECO MODE: When ECO MODE is activated, the scale will turn itself OFF after a preset amount of time.
To change ECO MODE, press OK when ECO MODE is shown in the Setup Menu. Press < or > to choose OFF, 
minutes,  minutes,  minutes or  minutes. Press OK to conrm your choice.
[EN]