rav KPH-40ECGA - User Manual

Other manuals for rav KPH-40ECGA

Questions and Answers

N
ncastilloAug 9, 2025
How to troubleshoot a rav KPH-40ECGA Lifting Systems when the motor does not run?
- L
  Laurie BryantAug 10, 2025
  If the motor of your rav Lifting System isn't running, there are several potential causes. First, check for a blown fuse or circuit breaker and replace or reset it. Ensure the motor is receiving the correct voltage. Inspect wiring connections for issues, repairing and insulating as needed. The motor up switch or overhead limit switch might be burned out, requiring replacement. In a worst-case scenario, the motor windings could be burned out, necessitating motor replacement.
J
Joshua BoltonAug 15, 2025
What to do if the motor runs but the rav KPH-40ECGA Lifting Systems lift won't raise?
- R
  Robert PowersAug 15, 2025
  If the motor of your rav Lifting Systems runs but the lift doesn't raise, consider these possibilities. The lowering valve might be open, requiring repair or replacement. The pump could be sucking air, so tighten all suction line fittings. Check if the suction stub is off the pump and replace it if necessary. Also, verify the oil level and fill the tank to the proper level with ISOVG32 Hydraulic Oil or Dexron III ATF.
M
Michelle Potter MDAug 20, 2025
Why is the lifting speed slow or oil blowing out of the filler breather cap in my rav Lifting Systems?
- C
  chaneybrandyAug 20, 2025
  If your rav Lifting Systems exhibits slow lifting speed or oil blows out of the filler breather cap, it could be due to a couple of reasons. The equalizer cables might be out of adjustment; in this case, adjust the equalizer cables to the correct tension. Alternatively, the lift might be installed on an unlevel floor, which requires tightening all suction line fittings and changing the oil using ISOVG32 Hydraulic Oil or Dexron III ATF.
K
Katherine CastanedaAug 25, 2025
How to fix a rav Lifting Systems that is going up unlevel?
- J
  Jill MorseAug 26, 2025
  If your rav Lifting Systems is going up unlevel, it could be due to insufficient concrete floor thickness or holding strength, in which case you should adjust the equalizer cables to correct tension. If not, shim the lift to level the columns, but do not exceed 1/2”. If it's over 1/2”, break out the floor and repour per lift installation instructions.
J
John SmithAug 30, 2025
What to do if my rav Lifting Systems lift slowly settles down?
- K
  Kristy Elliott MDAug 30, 2025
  If your rav Lifting Systems lift slowly settles down, it might be due to air mixed with oil, requiring you to clean the check valve. Another potential cause is air mixed with oil suction, so clean the lowering valve. Alternatively, the oil return tube could be loose, so repair external leaks.
P
Paula LeeSep 4, 2025
Why does my rav KPH-40ECGA Lifting Systems stop short of full rise or chatter?
- L
  Leslie HernandezSep 4, 2025
  If your rav Lifting Systems stops short of full rise or chatters, fill the tank to the proper level with ISOVG32 Hydraulic Oil or Dexron III ATF. Also, bleed the lift per the installation instructions if your lift has bleeders.