Ravaglioli RAVTD1780WS Series User Manual

SERVICE MANUAL
RAVAGLIOLI S.p.A.
RAVTD5040WD / 5060WD / 5080WD
RAVTD5080WS - RAVTD1760WS/1780WS
RAVTD1850WS - RAVTD2200WS
Code R0184 - rev.1.2
(01/2011)
Ravaglioli S.p.A. - Via I° Maggio, n° 3 (Frazione di Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 e-mail: rav@ravaglioli.com
FOR USE BY AUTHORISED
RAVAGLIOLI S.p.A. AFTER-SALES CENTRES
WHEEL ALIGNER EQUIPMENT
RAVTD5040WD / 5060WD / 5080WD
RAVTD5080WS - RAVTD1760WS/1780WS
RAVTD1850WS - RAVTD2200WS series
TEST AND SETTING OPERATIONS
AFTER-SALES MANUAL

Ravaglioli RAVTD1780WS Series Specifications

General

Category	Measuring Instruments
Model	RAVTD1780WS Series
Type	Wheel Alignment System
Power	0.5 kW
Air Pressure	8 bar
Power Supply	110/230 V 1ph 50/60 Hz

Summary

0 Introduction

1 Installation and Updating of the RAV Program

1.1 Installation

Details the software installation procedure, system requirements, and prerequisite software.

1.2 Update

Instructions for updating the RAV Wheel Aligners AS9 series software and data bank.

1.3 Setting the logo of the dealer

Procedure to customize printouts with a dealer logo image file (DEALER.PNG).

2 Connections

2.1 Connecting to the power line

Connects the aligner console to the power supply, specifying voltage and maximum power usage.

2.2 Connecting the measuring heads to the console

Explains head connection via Bluetooth or cables and the head charging process.

2.2.1 Combining of the "Bluetooth” heads with the cabinet

Details the process for pairing Bluetooth measuring heads with the main unit.

2.2.2 Linking of the "Wired" heads with the cabinet

Instructions for connecting wired measuring heads to the PC using serial ports.

2.3 R.M.S. device connection

Guide for connecting the Remote Measuring System (RMS) device via PC serial port.

2.4 Electronic Turntables STDA43K connection

Describes connecting electronic turntables to measuring heads via Bluetooth.

2.5 Connection of sensors and internal measuring head devices

Overview of internal connections within measuring heads and their components.

3 Calibrations

3.1 Measuring head calibration

Procedure for calibrating measuring heads, when needed, and the systems used.

3.2 Caster compensation procedure

Adjusts caster readings to correct for vehicle longitudinal level differences.

3.3 Steering Self calibration procedure

Calibrates the steering wheel's straight position after vehicle adjustments.

4 Test Procedures

4.1 Reading FW release (test for communication)

Verifies communication by displaying firmware versions of measuring heads.

4.2 Reading all angles horizontal/vertical

Displays all angle readings from heads, grouped into five categories.

4.3 Encoder on turntables Test

Tests turntable encoders by verifying readings during rotation.

4.4 Encoder on Measuring heads Test

Tests measuring head encoders by verifying readings during shaft rotation.

4.5 Keyboard Test

Tests the functionality of the measuring head keyboards.

4.6 Counter of the performed aligner test

Shows counters for diagnosed, regulated, and saved vehicle tests.